Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 16)

access code each time you change your primary access

code.

Temporary Access Code

The temporary access code allows you to perform all system commands except

changing access codes and bypassing sensors directly. The system allows you to

have one temporary access code. You might give the temporary access code to a

babysitter or other service personnel.

■

To add or change the temporary access code:

1. Enter primary

ACCESS CODE + STATUS + 7.

The panel beeps once.

2. Enter the temporary

ACCESS CODE.

After five seconds, the panel announces, [temporary access code] OK,

indicating that the temporary access code was changed.

■

To disable the temporary access code:

1. Enter primary

ACCESS CODE + STATUS + 7.

The panel beeps once.

2. Enter the primary

ACCESS CODE.

After five seconds, the panel announces, [primary access code] OK, indi-

cating that the temporary access code was deleted.

NOTE: If your temporary access code is disabled, then changing

your primary access code will automatically make your

old primary access code the new temporary access

code. If you want the temporary access code to remain

disabled, you must disable it again using your new primary

access code each time you change your primary access

code.

Secondary Access Codes

Secondary access codes allow you to perform all system commands, except

changing access codes and bypassing sensors directly. You can have up to four

secondary access codes. The secondary access codes can be used in the same way

as the temporary access code, except the secondary access codes can only be set

and changed by your security consultant.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 60 61

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 16