Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 34)

■ To disarm the system from a Keychain Touchpad:

1. Enter the premises through a delay door when the system is armed to level 2 or 3.

The panel and interior sirens sound a two- or three-beep sequence, with a one-second

pause between sequences. The beeping lasts for the entire delay or until you disarm

the panel. You must disarm the system before the delay time expires or an alarm will

occur.

CAUTION: Exit the premises immediately if the two- or three-beep

sequence sounds at a more rapid pace. This indicates an

alarm has occurred. Call for emergency help from a

neighbor’s phone.

2. Press the Disarm button on the Keychain Touchpad.

The AWAY or STAY light turns off, and the panel and interior sirens sound one short

beep.

NOTE: Pressing the Disarm button will not disarm the system if an alarm

was generated by simultaneously pressing the Arm and Disarm

buttons.

CAUTION: If you disarm the system before entering the premises, do

not enter the premises if you hear a two-beep continuous

sequence (1 long, 1 short). This indicates an alarm has

occurred. Call for emergency help from a neighbor’s

phone. For more information on this feature, contact your

security consultant.

3. Press the

STATUS

button to learn if there are any system problems.

■

To bypass sensors indirectly from a Keychain Touchpad:

1. Press the Arm button. If the panel announces, Sensor [sensor #] open and sounds a

two-beep continuous sequence (1 long, 1 short), continue to step 2.

If the panel arms successfully, you do not have to bypass any sensors.

2. Press the Arm button again.

Depending on which level you arm to, the panel’s STAY or AWAY light turns on, the

panel and interior sirens sound two or three beeps, and the panel announces,

Sensor

[sensor #] bypassed

NOTE: The indirect bypass procedure cannot be used in UL listed installa-

tions.

■ To activate an alarm from a Keychain Touchpad:

Simultaneously press the Arm and Disarm buttons until the light blinks to activate an

alarm type set by your security consultant.

The interior and exterior sirens and the panel sound the appropriate alarm. Exterior

sirens do not sound for auxiliary/medical alarms.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 60 61

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 34