Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 28)

3. Press the Arm button, then press the Star button and hold until the light blinks.

The Panel’s STAY or AWAY light turns on, and the Panel and interior sirens sound

arming level beeps. The NO DELAY light turns on, and the Panel and interior sirens

sound arming level beeps again.

NOTE: Disarm the system before opening a perimeter door or window, or

an accidental alarm may occur.

NOTE: Depending on programming, a Keychain Touchpad may arm

your system to the next higher arming level, or directly to level 3

NO DELAY.

Bypassing Normally Armed Sensors

(BYPASS)

Use the Bypass feature to ignore selected sensors, so they can remain open or so they can

be opened and closed without sending an alarm. Bypassing a window sensor allows you to

leave the window open while the system is armed. Bypass also allows you to ignore a sen-

sor that is not working properly and is causing unwanted alarms. You can bypass all sen-

sors for any security level in which they are active, except smoke, heat, and fire pull

sensors. Bypassed sensors remain bypassed until you change security levels.

You can bypass sensors indirectly or directly. Indirect bypassing lets you bypass open sen-

sors when the system will not arm. Direct Bypass lets you bypass sensors when the system

is armed and operating normally.

■

To bypass sensors indirectly:

1. Arm the system. If the panel announces, Sensor [sensor #] open and sounds protest

beeps, continue to step 2.

If the panel arms successfully, you do not have to bypass any sensors.

2. Press

BYPASS.

The panel announces, Alarm system is ON [level #]. Sensor [sensor #] bypassed.

NOTE: The indirect bypass procedure shall not be used in UL listed installa-

tions.

NOTE: The indirect bypass procedure does not work when you arm the

panel by pressing the COMMAND button rather than entering your

access code.

■

To bypass sensors indirectly from a Keychain Touchpad:

1. Press the Arm button. If the panel announces, Sensor [sensor #] open and sounds a

two-beep continuous sequence (1 long, 1 short), continue to step 2.

If the panel arms successfully, you do not have to bypass any sensors.

BYPASS

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 60 61

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 28