Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 45)

SECTION 6–

TROUBLESHOOTING YOUR SYSTEM

Table 10 provides basic troubleshooting information.

Table 10

. Troubleshooting Your System

Problem Solution

Access Code

Cannot remember access code.

Contact your security consultant.

Arming/Disarming

System won’t arm. • If arming to level 2, make sure all monitored perimeter

doors and windows are closed.

• If arming to level 3, make sure all perimeter and inte-

rior sensors are closed.

•Press

STATUS

for a voice message of the problem.

• If system still won’t arm, contact your security consult-

ant.

Batteries

Panel announces,

System

battery failure.

Panel announces, Sensor

[sensor #] low battery

Replace panel backup batteries as described in “Replac-

ing Panel Backup Batteries” on page 41.

See “Replacing Smoke Sensor Batteries” on page 44 for

the procedure to replace your own smoke sensor batter-

ies, or contact your security consultant to have your other

sensor batteries replaced.

Bypass

Panel announces,

Invalid, try

again

when you attempt to

bypass a sensor.

You are trying to bypass a 24-hour sensor that cannot be

bypassed or a sensor that is not active in the current secu-

rity level. You don’t need to bypass this sensor.

System cancels sensor bypass

when you try to arm to level 2 or

Arm to the desired level before you try bypassing a sen-

sor.

False Alarm

Alarm is being sent.

Enter

ACCESS CODE + 1

to cancel the alarm. This com-

mand bypasses the alarm if done within 8 to 20 seconds.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 60 61

Comentarios a estos manuales

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 45

Comentarios a estos manuales