Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 42)

CAUTION: The panel may be damaged if the wrong batteries are

installed. Make sure the batteries are all the same type

and part number.

NOTE: Use only the following batteries:

Alkaline:

Eveready E91, Duracell MN1500, Panasonic AM3X

NiCd:

Panasonic P-70 AAS or P-60AA, Sanyo N-600-AA

■

To replace the panel’s backup batteries:

1. Enter ACCESS CODE + 1 to disarm the system to level 1. An alarm will occur if you

do not disarm the system.

2. Loosen the two screws on the bottom of the panel until you are able to slide the door

down and out (see Figure 5). Two full turns should be enough to allow you to remove

the battery door without removing the screws completely.

Figure 5

. Loosen the two battery door screws

3. Check the battery type installed (NiCd or alkaline). You must use the same battery

type that is currently installed (see Figure 6).

OWER

EADY

TAY

WAY

ELAY

ROUBLE

NICAD

ALKALINE

USE ONLY

BATTERY CAPACITY FOR

BATTERY DOOR SCREWS

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 60 61

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 42