Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 32)

NOTE: You must reprogram the Magic Key whenever you change your

primary access code.

■ To program Magic Key for temporary access:

1. Enter primary

ACCESS CODE + STATUS + 7 +

new temporary

ACCESS CODE.

The panel announces, [new temporary access code] OK.

NOTE: You can enter your current temporary access code in place of a

new temporary access code if you do not want to change your

code.

2. Enter the number of days (00-99) you want the Key to work.

If you enter 00, the Key will work until midnight of the day the Key is programmed.

For numbers greater than 00, the Key will work until midnight of the assigned day.

3. Insert the Key into the slot within 30 seconds of changing your temporary access code

(see Figure 4).

4. Hold the Key in the slot until the panel announces,

Memory OK.

NOTE: You must reprogram the Magic Key if you change the temporary

access code.

Magic Key Voice Messages

Table 6 describes voice messages you may hear when programming or using a

Magic Key.

Using the Keychain Touchpad

This section summarizes all the functions of the Keychain Touchpad. You can perform the

following functions using the Keychain Touchpad:

Arm the system

Arm the system with no alarm delay time

Disarm the system

Table 6

. Magic Key Voice Messages

Message Definition

Memory OK

Programming successfully completed.

Invalid, try again.

Key not recognized. Repeat procedure.

Failure, good-bye.

Key’s programming prevents its use at this time.

Reprogram Key or revalidate the temporary

access code.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 60 61

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 32