Connect-Tek Transa PRO 17 El manual del propietario descargar pdf (Pagina 29)

2. Press the Arm button again.

Depending on which level you arm to, the panel’s STAY or AWAY light turns on, the

panel and interior sirens sound two or three beeps, and the panel announces,

Sensor

[sensor #] bypassed.

NOTE: The indirect bypass procedure cannot be used in UL listed installa-

tions.

■ To bypass sensors directly:

1. Enter primary

ACCESS CODE + [2 OR 3]

to arm the system to the desired level.

2. Enter primary

ACCESS CODE + BYPASS + [SENSOR #].

Sensor numbers range from

01 to 18.

The panel announces,

Sensor [sensor #] bypassed.

3. Repeat step 2 to bypass another sensor.

NOTE: You cannot bypass fire sensors, which include smoke, heat, and

fire pull sensors. But you can bypass 24-hour police and auxiliary/

medical sensors, including sensors in level 1 (see Table 5 for sensor

numbers).

■ To remove all sensor bypasses:

Change the security level.

■

To remove a single sensor bypass:

1. Enter primary

ACCESS CODE + BYPASS + [SENSOR #].

The panel announces, Sensor [sensor #] ON.

If the panel announces, Invalid, try again, check that the sensor is closed, then repeat

step 1.

2. Repeat step 1 to remove another sensor bypass.

Using the Chime Feature (CHIME)

The Chime feature causes the system to sound chime beeps whenever a monitored perim-

eter door or window is opened. Chime only works in level 1, when the system is disarmed.

■

To turn Chime on or off:

1. Enter

ACCESS CODE + 1

from the panel or a touchpad to disarm the system.

2. Enter

ACCESS CODE + 7.

or– Enter

COMMAND + 7.

The panel announces, ON or OFF.

CHIME

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 60 61

Comentarios a estos manuales

Sin comentarios

Connect-Tek Transa PRO 17 El manual del propietario Pagina 29

Comentarios a estos manuales